ABB ControlIT 53MC5000 User Manual

3.12.4 CONFIGURE A DATAPOINT
The following procedure illustrates how to alter the contents of datapoint C115 (CONTROL module &
Span parameter) from 100 to 200.
3.12.4.1 Procedure to Configure a Datapoint
•
Press the
Mode
button to enter the ENGINEER
mode indicated by the appearance of either
CONFIG-
URE
,
DISPLAY
or
PROGRAM
at the bottom of the
display.
•
If CONFIGURE does not appear, press F2 until
CON-
FIGURE
appears at the bottom of the display.
•
When
CONFIGURE
is displayed at the bottom, press
F3.
•
If using the Hi-Res display, as shown, press F2 until
DATAPOINT
appears at the bottom of the display.
•
Then press F3 to enter
DATAPOINT
mode.
•
The screen should now show the point-entry line similar
to the one at the right.
•
Press the key until the character "C" appears on
the entry line.
•
Press the key to shift the first entry one position to
the left.
•
Press the key until "1" appears on the entry line.
•
Press the key to shift this entry one position to the
left.
•
Press the key until "1" appears on the entry line.
•
Press the key to shift this entry one position to the
left.
•
Press the key until "5" appears on the entry line.
•
The entry line should appear similar to that shown on
the right.
•
Press F3.
53MC5000 Process Control Station
3-14

ABB ControlIT 53MC5000 Specifications

General

Brand	ABB
Model	ControlIT 53MC5000
Category	Controller
Language	English