ABB ControlIT 53MC5000 User Manual

•
The screen should now appear as shown on the right.
•
If the required key-code is "222222", follow the follow-
ing procedure.
•
Press the key until the digit "2" appears on the
entry line.
•
Press the key to shift the first entry one position to
the left.
•
Press the key until the next "2" appears on the
entry line.
•
Press the key to shift this entry one position to the
left.
•
Repeat this procedure until all of the key-code charac-
ters have been entered on the entry line.
•
The display should now look as shown on the right.
•
When all of the characters have been entered, press
F3.
•
Pressing the F3 key enters the password key and en-
ables display and entry of either the
MODULE
or
DATAPOINT
modes which will be discussed later.
•
The engineer mode configuration function is now ready
for use.
•
The screen should now appear as shown in one of the
following screens (the rightmost screen represents the
low-resolution display).
53MC5000 Process Control Station
3-10

ABB ControlIT 53MC5000 Specifications

General

Brand	ABB
Model	ControlIT 53MC5000
Category	Controller
Language	English