ABB SACE Tmax XT2 User Manual

1SDH002031A1002 ECN000092998 Rev. B SACE Tmax XT2 – XT4 | 129
38 - Ekip Cartridge
Ekip Cartridge is an external accessory that can be installed on a standard 35 mm DIN rail (DIN
EN 50022 type TS 35x15 mm), which allows other external accessories to connect to Ekip Touch:
 All cartridge modules (e.g. Ekip Supply, Ekip Com, etc)
 engaged/disengaged signal contact, in case of a CB in a detachable configuration
Models
Two different models are available that allow two or four modules to be connected respectively.
IMPORTANT: one module must always be Ekip Supply
Connections
Ekip Cartridge has two terminal blocks:
Figure 30
Connector
Description
1
Terminal for connecting the engaged/disengaged status contact
NOTE: by default Ekip Cartridge is supplied with a jumper on the terminal
block
To use the engaged/disengaged status signal, remove the jumper from the
connector and connect the cables coming from the fixed part of the CB
2
Terminal for the connection of Ekip Cartridge to Ekip Touch:
Pin
Description
K2
Power output for Ekip Touch (+24V DC)
K1
Power output for Ekip Touch (-24V DC)
W3
CAN bus
W4
CAN bus
Access to all external connections are available on the respective modules, on the top side of
Ekip Cartridge.
Assembly
To connect the module to Ekip Touch see the instruction sheets 1SDH002009A1503.
2
1

ABB SACE Tmax XT2 Specifications

General

Brand	ABB
Model	SACE Tmax XT2
Category	Circuit breakers
Language	English