ABB SACE Tmax XT2 User Manual

1SDH002031A1002 ECN000092998 Rev. B SACE Tmax XT2 – XT4 | 31
12 - Change parameters and commands
Change
parameters
To change one or more parameters follow the procedure below.
IMPORTANT: parameters can be changed with the Trip unit in Local mode and
with no timing alarms
Step
Description
1
Press the Enter button to select the parameter you want to change and enter the
password, if requested.
2
Select the desired new value using the Right/Up and Left/Down buttons:
 from the list showing all available values
 with bar min/max:


Figure 15
3
Pressing the Enter button selects the desired value.
The display automatically shows the submenu of the higher level and the changed
parameter shows a confirmation check mark:
Figure 16
At this point it is possible to confirm the programming (Step 4) or to access other
parameters for further changes (Step 1).
4
Press the ESC button to return to the previous menu until the Programming page
appears.
The Programming page accepts different commands:
 Confirm to validate the new parameters and complete the programming
 Cancel to exit without saving
 Change to return to the menus and change the parameter
Figure 17
Use the Right/Up and Left/Down buttons to move to the desired item, and confirm
by pressing the Enter button.

ABB SACE Tmax XT2 Specifications

General

Brand	ABB
Model	SACE Tmax XT2
Category	Circuit breakers
Language	English