ABB SACE Tmax XT2 User Manual

1SDH002031A1002 ECN000092998 Rev. B SACE Tmax XT2 – XT4 | 113
Settings
31 - Main settings
Introduction
All the following parameters are available directly or from the Settings menu in the conditions
envisaged by Ekip Touch based on the version and configuration described.
Please refer to the overview of the Settings menu on page 29 for a discussion of the parameters
in the menu but not described below:
 Circuit breaker: Hardware Trip, T Protection, Neutral Protection
 Phase sequence
 Measurement range
 Power Controller,
 Load Shedding,
 Network Analyzer
 Datalogger
 Dual Setting
 Functions
WARNING! changes to the settings must be made without protection alarms
Configuration
The Circuit breaker-Configuration menu is available with CB 3P, which allows activating the
presence of the external neutral sensor (described on page 204).
Activation of the configuration with external neutral (3P + N) enables:
 Histogram of the Ne phase on the Histograms page
 Neutral current measurements
 Submenu for configuring the Neutral protection
 Logging of neutral current in case of TRIP
With CB 3P by default the parameter is set as: 3P.
Grid frequency
Sets the system's grid frequency. Possible choices are 50 Hz and 60 Hz.
NOTE: measurements are performed according to the grid frequency set. An incorrect
parameter configuration can cause measurement and protection malfunctions
Ekip Touch is supplied with the parameter set according to the configuration ordered.

ABB SACE Tmax XT2 Specifications

General

Brand	ABB
Model	SACE Tmax XT2
Category	Circuit breakers
Language	English