ABB SACE Tmax XT2 User Manual

1SDH002031A1002 ECN000092998 Rev. B SACE Tmax XT2 – XT4 | 14
Management operations
Life cycle
Proper management of SACE Tmax XT involves the following operations:
Figure 7
Operation
Description
Receipt
Unpacking and verification of the material received
Installation
Assembly operations
Startup
General preliminary checks
Maintenance and
malfunctions
Periodic checks and cleaning, management of alarms or
malfunctions
Decommissioning
End of life and disposal
This document describes the operations of Startup and Maintenance and malfunctions for Ekip
Touch. For other operations see the Installation Instructions and the Technical Catalog, see page
4 for references.
7 - Startup
General checks
Before startup it is necessary to perform the following checks:
Points to
inspect
Checks
Main
connections
Ground connections
If present, connection and tightness of the external Neutral voltage (V0)
If included, connection of the power supply through the terminal board
If present, connection of the power supply/Ekip Supply module
Alarms
If not powered, connect the Ekip TT device to Ekip Touch and make sure
that there are no alarms (details on page 18)
Parameters
Configure all unit parameters appropriately

ABB SACE Tmax XT2 Specifications

General

Brand	ABB
Model	SACE Tmax XT2
Category	Circuit breakers
Language	English