Rockwell Automation Publication 750-IN001P-EN-P - April 2017 11
Preface
Commonly Used Tools
Installation and Service Tools
Use these tools to install the drive.
IMPORTANT Do not let tools or hardware components fall into open drive assemblies. Do
not energize the drive unless all tools and hardware components have been
removed from the drive assemblies and enclosure.
Tool Description Details
ESD-protected place of work Work surface, Floor cover, seat, and ground connections
ESD-protective clothing Wrist wrap, shoes, overall clothing (coat)
Multimeter Digital multimeter, capable of AC and DC voltage, continuity, resistance,
capacitance measurements, and forward diode bias tests. Fluke model 87 III
or equivalent.
Allen socket wrench 4 mm, 5 mm
Allen-socket wrench extension 254 mm (10 in.)
Flat-nose screwdriver 5 mm (0.19 in.), 6.4 mm (0.25 in.), 9.5 mm (0.375 in.), #1, #2
Hexalobular screw driver/bit #15, #20, #25, #40, #45
Hexagonal socket wrench 7 mm, 8 mm, 10 mm, 12 mm, 13 mm, 17 mm, 18 mm
Combination wrench 10 mm, 17 mm
Phillips screw driver/bit #2, 492-C
Pozidriv #2, M3 x 7
Torque wrench 1...12 N•m (8.8…106 lb•in)
Torque wrench 6...50 N•m (53…443 lb•in)
Roll-out cart 20-750-CART1-F8
IMPORTANT: The roll-out cart is required to remove Frame 8 and larger
drive assemblies from the enclosure.
To Next Page
Loading...
Need help?
General
