Rockwell Automation Publication 750-IN001P-EN-P - April 2017 149
Lift and Mount the Drive Chapter 3
3. Engage and tighten the capture screws to lock the drive assembly or
cabinet options assembly to the Stop.
4. To roll the drive assembly or cabinet options assembly away from the
cabinet, release the retaining clips.
ATTENTION: The drive assembly and cabinet options assembly have a high
center of gravity and a tip-over hazard exists. To guard against death, serious
personal injury, and/or equipment damage, do not subject the drive
assembly or cabinet options assembly to high rates of acceleration or
deceleration while transporting. Do not push or pull above the points
indicated.
IMPORTANT Take precautions when using the roll-out cart to move the drive.
• Only use the roll-out cart to move the drive or cabinet options a short
distance to gain access to the cabinet interior.
• Do not attempt to move the drive or cabinet options on the roll-out cart
with the handle alone. The roll-out cart handle is designed for
positioning the empty cart.
• Only use the cart on a smooth and level surface.
• Verify that the path for the cart is clear of debris and obstacles.
• Avoid sloped and rough surfaces.
• Always move the drive or cabinet options slowly.
To Next Page
Loading...
Need help?
General
