Rockwell Automation Publication 2080-UM002G-EN-E - March 2015 153
Chapter
9
Controller Security
Micro800 security generally has two components:
• Exclusive Access which prevents simultaneous configuration of the
controller by two users
• Controller Password Protection which secures the Intellectual Property
contained within the controller and prevents unauthorized access
Exclusive Access
Exclusive access is enforced on the Micro800 controller regardless of whether the
controller is password-protected or not. This means that only one Connected
Components Workbench session is authorized at one time and only an
authorized client has exclusive access to the controller application. This ensures
that only one software session has exclusive access to the Micro800
application-specific configuration.
Exclusive access is enforced on Micro800 firmware revision 1 and 2. When a
Connected Components Workbench user connects to a Micro800 controller, the
controller is given exclusive access to that controller.
Password Protection
By setting a password on the controller, a user effectively restricts access to the
programming software connections to the controller to software sessions that can
supply the correct password. Essentially, Connected Components Workbench
operation such as upload and download are prevented if the controller is secured
with a password and the correct password is not provided.
Micro800 controllers with firmware revision 2 and later are shipped with no
password but a password can be set through the Connected Components
Workbench software (revision 2 or later).
The controller password is also backed up to the memory backup module — that
is, 2080-MEMBAK-RTC for Micro830 and Micro850 and 2080-LCD for
Micro810 controllers.
Compatibility
The Controller Password feature is supported on:
• Connected Components Workbench revision 2 and later
For instructions on how to set, change, and clear controller passwords,
see Configure Controller Password
on page 200.
To Next Page
Loading...
Need help?
General
