46 Rockwell Automation Publication 20A-UM001N-EN-P - July 2013
Chapter 1 Programming and Parameters
DYNAMIC CONTROL (file D)
Restart Modes
169 [Flying Start En]
Enables/disables the function that reconnects to
a spinning motor at actual rpm when a start
command is issued.
Default:
Options:
0
0
1
“Disabled”
“Disabled”
“Enabled”
170
170 [Flying StartGain]
Sets the response of the flying start function.
Default:
Min/Max:
Units:
4000
20/32767
1
169
174 [Auto Rstrt Tries]
Sets the maximum number of times the drive
attempts to reset a fault and restart. Refer to the
PowerFlex Reference Manual, publication
PFLEX-RM004 for additional information.
Default:
Min/Max:
Units:
0
0/9
1
175
175 [Auto Rstrt Delay]
Sets the time between restart attempts when
[Auto Rstrt Tries] is set to a value other than
zero.
The HIM display shows AutoRst X,YY during the
restart delay. Where X is the number of restarts
left and YY is the time left before restart. For
delay times of 99 seconds or less, YY displays
the seconds remaining before restart. For delay
times greater than 99 seconds, YY changes to
the percent of delay time remaining before
restart.
Default:
Min/Max:
Units:
1.0 Secs
0.5/6000.0 Secs
0.1 Secs
174
File D
Group
No.
Parameter Name and Description
See page 14 for symbol descriptions
Values
Related
ATTENTION: Equipment damage and/or personal injury can
result if this parameter is used in an inappropriate application.
Do not use this function without considering applicable local,
national and international codes, standards, regulations or
industry guidelines.
Description Example Screen
Restarts Remaining = 8
Delay Time = 93 seconds
F-> AutoRst 8,93 Auto
F2
Auxiliary Input
Time Since Fault
00000:00:31
To Next Page
Loading...
Need help?
General
