Rockwell Automation Publication 7000-UM202D-EN-P - May 2018 113
Power Component Definition and Maintenance Chapter 2
Figure 98 - Expansion of V Sense Trigger to SCR Gating Pulse
Fiber Optic Cabling
The equipment uses fiber optic cabling between the low voltage control and
the medium voltage circuits. You should never need to change the routing of
the fiber optic cables.
Each end of a fiber optic cable has a connector that plugs and latches into its
respective location on a circuit board. To disconnect a fiber optic cable, depress
the ridged plastic tab at the end connector and pull. To install a fiber optic
cable insert the fiber optic port of the circuit board so that the plastic tab
latches into place.
If you must replace fiber optic cables, be careful to prevent the cables from
straining or crimping as a resulting loss in light transmission will impact
performance.
The minimum bend radius permitted for the fiber optic cables is 50 mm (2.0
in.).
When installing the fiber optic cable, match the connector color at the end of
the cable with the connector socket color on the circuit board.
To Next Page
Loading...
Need help?
General
