76 Rockwell Automation Publication 7000-UM202D-EN-P - May 2018
Chapter 2 Power Component Definition and Maintenance
Figure 63 - Replacing the SGCT (Heatpipe Model)
Replacing Snubber and Sharing Resistor
The snubber and sharing resistors are part of the resistor assembly located
behind the PowerCage module.
1. Remove the PowerCage module as outlined in Removing the
PowerCage Module on page 103.
Note the connection of the leads for correct replacement.
2. Detach the leads located on the bottom of the resistor assembly.
Clamp Head
DO NOT ADJUST
outside nut
Inside nut used for loosening
and applying load to assembly
Disc Springs
SGCT
Captive
Screws
To Next Page
Loading...
Need help?
General
