172 Rockwell Automation Publication 7000-UM202D-EN-P - May 2018
Chapter 3 Control Component Definition and Maintenance
This board provides the mechanical and electrical interconnections between
the OIBs and the DPM. The board connects to either J11 or J12 on the DPM
via a 60-conductor shielded-ribbon cable. Attach the cable drain wire to the
screw terminal J8. The remaining connectors on the board complete the
electrical connection of the installed OIBs to the DPM. Each OIB can support
from one to three OIBs.
Figure 142 - Optical Interface Base Board (OIBB)
To Next Page
Loading...
Need help?
General
