78 Rockwell Automation Publication 7000-UM202D-EN-P - May 2018
Chapter 2 Power Component Definition and Maintenance
3. Remove the push nuts on the end of the retaining rod.
4. Pinch the clip together and pull off.
5. Pull out the retaining rod.
Figure 66 - Snubber and Sharing Resistor Replacement (Heatsink Model)
Figure 67 - Snubber and Sharing Resistor Replacement (Heatpipe Model)
1. Detach leads of
resistor assembly
2. Pinch and remove
clips at end of retaining
rod
3. Extract
retaining rod
Detach the leads
of the resistor
assembly
Remove hardware
for resistor
retaining bracket
To Next Page
Loading...
Need help?
General
