Rockwell Automation Publication 750-IN100B-EN-P - July 2017 17
Product Overview Chapter 1
Configuration Tool Options
Any of the following configuration tools can be used:
• PowerFlex® 20-HIM-A6 or 20-HIM-C6S HIM
See the PowerFlex 20-HIM-A6 or 20-HIM-C6S HIM (Human
Interface Module) User Manual, publication 20HIM-UM001
.
• Connected Components Workbench™ (CCW) software R10.00 or later
• Connected Components Workbench is the recommended standalone
software tool for use with PowerFlex® drives. You can obtain a free copy
by internet download at the Product Compatibility and Download
Center
http://compatibility.rockwellautomation.com/Pages/home.aspx
• Controller configuration software, such as RSLogix 5000® software,
version 20.00 or later, or Studio 5000™ Logix Designer application,
version 21.00 and later.
• Automatic Device Configuration (ADC), an RSLogix 5000® software
feature, which supports the automatic download of configuration data.
The download occurs after the Logix controller establishes an
EtherNet/IP network connection to a PowerFlex® 755TL, 755TR, or
755TM product and its associated peripherals.
• A computer connection to the EtherNet/IP network.
Hardware Installation
Diagrams
The assembly illustrations throughout this manual contain diagrams as shown
here. These diagrams identify the corresponding sequence number when
required, type of fastener, fastener size, tool type and size, and final assembly
torque.
1
M4 x 10 mm
T20 or F - 6.4 mm (0.25 in.)
4.8 N
•m (42 lb•in)
Fastener Type
Flat-head screw
Hexagonal bolt
Hexagonal nut or standoff
Hexagonal screw
Hexalobular (star or Torx) screw
Phillips screw
POZIDRIV screw
Slotted hexalobular (star or Torx) screw
Corresponding
Sequence
Number
Tool Type and Size
F Flat-nose screwdriver
Px Phillips screwdriver/bit and size
PZx POZIDRIV screwdriver/bit and size
Txx Torx screwdriver/bit and size
xx mm Hexagonal socket wrench
Final Assembly Torque
Fastener Size
To Next Page
Loading...
Need help?
General
