Rockwell Automation Publication 750-IN100B-EN-P - July 2017 83
Mechanical and Electrical Installation Chapter 4
Install the LCL Filter Module in the Enclosure
Install the LCL filter module into the enclosure in the reverse order of removal.
When installing the fiber-optic cables:
1. Remove the transceiver from the fiber-optic connector port on the
power layer interface circuit board on the adjoining power module.
ATTENTION: LCL filter modules and power modules have a high center of
gravity and a tip-over hazard exists. To guard against death, serious personal
injury, or equipment damage, do not subject the module to high rates of
acceleration or deceleration while transporting. Do not push or pull above
the points indicated on the module.
To Next Page
Loading...
Need help?
General
