Shutdown Mode can be exited by disabling the triggering Low
Power/Shutdown Option (1, 2, 3, or 4) through Network and Ir-
DA commands. In addition, the Low Power/Shutdown Option (1,
2, 3, or 4) can be disabled using manual programming.
Power Failure Display Mode
In Power Failure Display Mode the control will show PrFAiL.
This informs the user that a cycle was interrupted and did not
complete normally. This mode is entered from Power-Up Mode if
a power failure occurred during an OPL cycle and the cycle is not
able to automatically resume. If the user presses any key, Start
Mode is entered.
Washer Operation
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
15 Part No. 204370ENR1
To Next Page
Loading...
Need help?
General