1. Control must be in Manual Mode. Refer to How to Enter the
Manual Mode.
2. Press the DELICATES (∧) or the COLD (∨) keypad until
Prog appears in the display. Press the START (enter) keypad,
and AtS 1 will appear in the display.
3. Press the DELICATES (∧) or the COLD (∨) keypad to scroll
through the programmable options until SP1- appears in the
display. Press the START (enter) keypad and SP1 1 will ap-
pear in the display.
4.
When SP1 1 appears in the display, press the START (enter)
keypad. A number will appear in the display that corresponds
to the current Special Vend 1 Days Enable Programming Val-
ue.
5. Locate the desired number in the first column of Table 8 .
6. Press the DELICATES (∧) or the COLD (∨) keypad to in-
crease or decrease the current number until correct.
7. Press the START (enter) keypad when the correct value ap-
pears in the display. The new value is saved and the next op-
tion will appear in the display.
How to Read the Days Enable Value Table
To determine the correct number required to program the Special
Vend Days Enable, Water Leak Detection Days of Week Enable
or the Lucky Cycle Day(s) of Week / Enable, use the following
table.
The Value column contains the number required in step 6. The
other columns correspond to individual days.
Each column of days contains a unique combination of the words
“ON” and “OFF” that indicates if that column’s day is turned on
or off when the value is entered. Select the desired combination
of days and enter the number found in the value column.
* The default value programmed at the factory is 0.
SP1 1, E Ld 1 and LUC 1
VALUE SAT FRI THUR WED TUE MON SUN ON/OFF
0* OFF OFF OFF OFF OFF OFF OFF OFF
3 OFF OFF OFF OFF OFF OFF ON ON
5 OFF OFF OFF OFF OFF ON OFF ON
7 OFF OFF OFF OFF OFF ON ON ON
9 OFF OFF OFF OFF ON OFF OFF ON
11 OFF OFF OFF OFF ON OFF ON ON
13 OFF OFF OFF OFF ON ON OFF ON
15 OFF OFF OFF OFF ON ON ON ON
17 OFF OFF OFF ON OFF OFF OFF ON
19 OFF OFF OFF ON OFF OFF ON ON
21 OFF OFF OFF ON OFF ON OFF ON
23 OFF OFF OFF ON OFF ON ON ON
25 OFF OFF OFF ON ON OFF OFF ON
27 OFF OFF OFF ON ON OFF ON ON
29 OFF OFF OFF ON ON ON OFF ON
31 OFF OFF OFF ON ON ON ON ON
33 OFF OFF ON OFF OFF OFF OFF ON
Table 8 continues...
Programming Control
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
48 Part No. 204370ENR1
To Next Page
Loading...
Need help?
General