WHILE PURGING THE HYDRAULIC SYSTEM, FILL THE RESERVOIR WITH THE NECESSARY
QUANTITY OF BRAKE FLUID. CHECK THAT, DURING THE OPERATION, THERE IS ALWAYS
BRAKE FLUID IN THE RESERVOIR.
•
Screw the bleeding valve and remove the pipe.
•
Top-up the reservoir until the correct brake fluid level is obtained.
•
Refit and block the front brake oil reservoir cap.
•
Refit the rubber protection cover.
Rear drum brake
Rimozione
•
Remove the drum brake control rod
•
Remove the complete rear wheel
•
Extract the complete drum brake from
the wheel rim
•
Remove the nut (1) and the fixing
screw (2) of the brake lever, paying at-
tention to collect the washers
•
Remove the brake lever (3)
Braking system ETX - STX 150
BRAK SYS - 136
To Next Page
Loading...
Need help?
General
