SBS COSMOS
REFRIGERATOR 10.01.2014 / REV NO: 03
22
7
• Press on the “Ice Off” button on the screen. Push the bypass cover in Picture 3 in the
direction of arrow to remove.
• Remove the water valve union seen in Picture 1 and attach it to the water pipe and
tighten the union.
• Water filter is grouped as shown in Picture 6.
WARNING: Make sure that the “Ice Off” mode is active before
taking out the by-pass cover.
WARNING: Water filter cleans some foreign particles contained in
the water. It does not purify the water from microorganisms.
WARNING: “Ice Off” button must always be pressed during replacement of
the water filter or when installing the by-pass cover.
It is normal that a few drops of water drip after the cover has been taken out.
Water filter should be replaced every 6 months. Remove the water filter and
install the bypass cover as shown in the figure when you replace the water
filter or when it will no longer be used. Make sure that the “Ice Off” mode is
active before taking out the filter.
6.3. Connecting the water pipe to the cold water mains line
If you will use the refrigerator by connecting it to the mains cold water supply, you need to
connect a standard 1/2" valve fitting to the mains cold water supply in your house.
WARNING: Secure the water pipe to suitable points by means of
the clips supplied to avoid any damage or displacement or
accidental disconnection.
To Next Page
Loading...
Need help?
General
