12.7. Trigger silicon part
Used service number: 1187
• It is used in the Icematic group and Container group.
• It is used to suppress the noise. Remove by pulling.
12.8. Door-in-Door (DID) cover group
Service numbers used:
1267 Beko DID cover group
Beko DID cover group
• Pull the spring inside using a screwdriver through the hole on the right part of DID cover
as in Picture 2 and and pull the pin out of its housing on the right of DID.
• After taking out the pin on the left side, remove DID from its place.