34.16
[RS] Removing and installing front
ABS sensor
•
Remove the right side section of the fairing.
•
Remove front mudguard.
•
Separate plug connector (1) in sensor line.
•
Remove sensor (2) with Torx T 25.
•
Install in the reverse order of work.
e Caution:
Run the sensor line correctly.
Check sensor gap and adjust if necessary with
spacer plate (3).
Sensor gap:.. 0.45...0.55 mm (0.0177...0.02165 in)
X Tightening torque:
Sensor ..........................................handtight, 4 Nm
1
3
2
RS340090
To Next Page
Loading...
Need help?
General
