00.31
Adjusting Poly-V belt
(Inspection I, II, III)
Renewing Poly-V belt
(40 000 km/24 000miles)
(renew maintenance-free belts every 60 000 km/
36 000 miles)
•
[RS/RT] Remove left side fairing.
•
[R] Remove left fuel tank cover.
•
Remove front cover.
•
Slacken off alternator mounting screws (1,3,4)
and install a new Poly-V belt if necessary.
Poly-V belt adjusting procedure:
Poly-V belt installation procedure:
•
Place the Poly-V belt in position, tension it and
turn the engine over once, then release belt ten-
sion.
Poly-V belt tensioning procedure:
•
Screw hex nut (1) on adjusting screw (2) up
handtight (no tools to be used!)
•
Tighten adjusting screw (2) with a torque wrench,
fully tighten retaining nut (3), slacken adjusting
screw and tighten screws fully.
X Tightening torque:
Poly-V belt preload......................................... 8 Nm
Alternatorto alternator support cover............ 20 Nm
L Note:
aSee also Service Information 12 020 95 (700).
2
1
4
3
RS110480
RS110490
To Next Page
Loading...
Need help?
General
