36.8
Removing and installing wheel bear-
ings
•
Remove shaft seal, driver and retaining ring.
•
Clamp arbor, BMW No. 36 5 511, in vise and
place wheel on it with the broad bearing in con-
tact with the arbor.
•
Place spacing ring, BMW No. 31 4 800, between
wheel hub/right side of wheel and claws of inter-
nal puller.
•
Heat bearing seat to 80 °C.
•
Pull out wheel bearing with counter-support
22/1, BMW No. 00 8 572, and internal puller
21/3, BMW No. 00 8 574.
•
Press out spacing bushing (1) and wheel bearing
(2) with drift, BMW No. 36 5 530.
•
Press reducing bushing out of bearing with drift,
BMW No. 36 5 530/ into new bearing.
•
Degrease bearing seats.
RS360021
00 8 572
00 8 574
31 4 800
j
80
RS360024
36 5 530
1
2
RS360023
To Next Page
Loading...
Need help?
General
