36.7
Removing and installing front wheel
Removing front wheel
•
[RS/RT] Remove front mudguard.
•
Remove brake calipers.
e Caution:
[RS/R/RT] Do not scratch rim; mask off with tape if
necessary. Do not tilt the brake caliper: risk of dam-
age to brake pads.
L Note:
Do not apply handbrake lever with brake calipers re-
moved/front wheel removed.
•
Remove retaining screw (1).
•
Loosen clamping screws (2).
•
Remove quick-release axle.
•
Remove spacer bushing (3)
and speedometer drive.
•
Remove front wheel.
Installing front wheel
•
Install front wheel.
•
Install spacer bushing and speedometer drive.
e Caution:
Anti-twist device (arrow) on speedometer drive is lo-
cated in front of stop on slider tube.
•
Apply a light coating of Molykote paste to the
quick-release axle/install it.
•
Tighten retaining screw (1).
•
Press forks down firmly several times.
•
Tighten clamping screws (2).
•
Install brake calipers.
•
[RS/RT] Install front mudguard.
•
[ABS] Check sensor gap and adjust if necessary.
ABS sensor gap.............................0.45...0.55 mm
.............................................. (0.0177...0.02165 in)
X Tightening torque:
Screw connection, quick-release axle.......... 30 Nm
Clamping screws, quick-release axle ........... 22 Nm
Brake caliper to slider tube .......................... 40 Nm
1
2
3
RS360011
To Next Page
Loading...
Need help?
General
