D9412G/D7412G | Program Entry Guide | 5.0 RADXSKED EN | 103
Bosch Security Systems | 10/03 | 47775E
UW# Sunday
Default: No
Selection: Yes or No
This prompt, and the next six day of the week
prompts, select the days of the week that the User
Group Window is active.
0101
0101
0101
See the W# Sunday prompt in Section
5.1.1 Opening and Closing instructions
for more information about programming
this prompt.
UW# Monday
Default: No
Selection: Yes or No
UW# Tuesday
Default: No
Selection: Yes or No
UW# Wednesday
Default: No
Selection: Yes or No
UW# Thursday
Default: No
Selection: Yes or No
UW# Friday
Default: No
Selection: Yes or No
UW# Saturday
Default: No
Selection: Yes or No
UW# Group Enable
Default: 00:00
Selection: HH:MM (hours and minutes)
This prompt must be programmed if this
User Group Window is assigned to a user
group.
Enter the time of day that the window starts.
Beginning at this time, users assigned to this
window’s group can use their passcodes. The
window goes into effect at the beginning of the
minute. Make entries using a 24-hour clock (for
example, 7:00 AM is entered as 07:00, 2:45 PM is
entered as 14:45).
Disable/Restart the control panel to activate today’s
window. If you are programming a window that
needs to activate on the same day that you are
programming it, do a disable/restart after
programming.
UW# Group Disable
Default: 00:00
Selection: HH:MM (hours and minutes)
This prompt must be programmed if this
User Group Window is assigned to a user
group
Enter the time of day that the window ends. This
time marks the end of the period in which users
assigned to this window’s group can use their
passcodes. The window stops at the end of the
minute. Make entries using a 24-hour clock (for
example, 7:00 AM is entered as 07:00, 2:45 PM is
entered as 14:45).
To disable the window, both the hours and minutes
spaces must be blank.
Do not program a single window to cross the
midnight boundary. The window stop time must be
later than the window start time.
To Next Page
Loading...
Need help?
General
