Bosch D7412G Program Entry Guide

D9412G/D7412G | Program Entry Guide | 2.0 9000MAIN EN | 18
Bosch Security Systems | 10/03 | 47775E
Fire Reports
Selecting Yes enables a report to be sent when the
event occurs.
Table 9: Diagnostic Reports
Report Selections Description
R# Fire Alarm
Yes, No
Reports Fire Event.
R# Fire Restore
(Alarm)
Yes, No
Reports fire restoral
from alarm.
R# Fire Missing
Yes, No
Reports missing Fire
point.
R# Fire Trouble
Yes, No
Reports fire trouble.
R# Fire
Supervis
Yes, No
Reports fire
supervision.
R# Fire Restore
(T/M/S)
Yes, No
Reports fire restoral
from trouble,
missing, or bypass.
R# Fire Cancel
Yes, No
Reports canceled
fire alarm.
R# Fire Sup
Miss
Yes, No
Report fire
supervisory missing.
R# Fire Supv
Rest
*
Yes, No
Reports restorals
from Fire
Supervision.
* This event is not reported when using BFSK format.
Burglar Reports
Selecting Yes enables sending a report when the
event occurs.
Table 10: Burglar Reports
Report Selections Description
R# Alarm
Yes, No
Report Burglar Alarm
Event.
R# Burg
Restore
Yes, No
Reports non-fire
restoral from trouble,
missing, or
supervisory.
R# Duress
Yes, No
Duress Report.
R# Missing
Alarm
Yes, No
Reports missing
Alarm point.
R# Usr Code
Tmpr
Yes, No
Reports user code
tamper.
R# Trouble Rpt
Yes, No
Reports Trouble
Event.
R# Missing Trbl
Yes, No
Reports Missing
Trouble Event.
R# Non Fire
Suprv
Yes, No
Reports Non-fire
Supervision Event.
R# Pt Bus Fail
Yes, No
Reports point bus
failure.
R# Pt Bus Rstl
Yes, No
Reports restoral of
point bus after failure.
R# Non Fire
Cncl
Yes, No
Reports canceled
non-fire alarm.
R# Alarm
Restore
Yes, No
Reports non-fire
restoral from alarm.
R# Sup Missing
Yes, No
Reports supervisory
missing.
R# Unverfied
Evt
†*
Yes, No
Reports Unverified
Events for Cross
points.
† This event is not reported when using BFSK format.
* This event does not produce a corresponding Restoral
Event.
0101
0101
0101
The Unverified Event is transmitted when a
single point programmed in Cross Point
Group faults into an alarm condition then
restores before the Cross Point Time
elapses. This event encompasses both
Fire and Non-fire points. It is not, however,
related to the Verify Time used for smoke
detectors.

Bosch D7412G Specifications

General

Partitions	8
Power Supply	16.5 VAC, 40 VA
User Codes	99
Users	99
Communication Formats	Contact ID, SIA
Operating Temperature	0°C to +49°C (32°F to +120°F)