130 Section 5: Removal/Installation
h. With throttle resting against the dead idle
screw, rotate the TPS until the output
voltage is 0.73 +/- 0.02 volts.
i. Alternately tighten two TPS screws to 10-
16 in-lbs (1-2 Nm).
24. See Throttle Body, Installation, steps 5-9.
25. Proceed to step 26 to reset ECM memory.
26. Reset ECM memory as follows:
a. Turn Ignition OFF for at least 10 sec-
onds.
b. Cycle Ignition ON and OFF fi ve times in
fi ve seconds.
c. End cycle in the OFF position and wait
at least 10 seconds.
d. Turn Ignition ON to reset ECM memory
to the default values.
HO
2
Sensor
Removal
1. Remove access cover. See Access Cover/
Blower Housing, Removal, steps 1-3.
2. See Air Cleaner Assembly, Removal.
3. Disconnect HO
2
sensor connector.
4. Rotate sensor body hex CCW to release
sensor from muffl er.
Installation
1. Rotate sensor body hex CW to secure
sensor to muffl er. Tighten to 146-173 in-lbs
(16-19 Nm).
2. Connect HO
2
sensor connector.
3. See Air Cleaner Assembly, Installation.
4. Install access cover. See Access Cover/
Blower Housing, Installation, steps 7-10.
To Next Page
Loading...
Need help?
General
