142
m
Remove the embroidery positioning sticker from the
fabric.
n
Touch to select the next section of the pattern to
be embroidered, and then touch .
o
Touch .
p
Touch , and then press the “Start/Stop”
button to start embroidering the next section of the
pattern.
When winding the bobbin thread onto a metal bobbin, use
the optional bobbin winder. The procedures for using the
optional bobbin winder are described below.
Precautions
For precautions concerning the power supply, refer to
page 22.
Optional bobbin winder and its accessories
Check that the following bobbin winder and accessories are
included. When the part code is “*”, contact your authorized
Brother dealer.
• If the built-in camera cannot detect the location of
the embroidery positioning sticker, the following
error message appears. Touch , return the
jumbo frame to its previous orientation, and then
perform the procedure again starting from step
h.
USING THE OPTIONAL BOBBIN
WINDER
• Be sure to place the bobbin winder on a level,
stable surface.
• Be sure to use the bobbins supplied with this
bobbin winder.
Part Name
Part Code
1.
1 Main power switch
2 Bobbin winder shaft
3 Hole for thread guide
4 Hole for spool pin
5 DC input connector
Bobbin winder
PRBW1
2. Spool pin
XC5949-051
3. Spool cushion
XA0679-050
To Next Page
Loading...
Need help?
General
Weight and Dimensions
