BASIC EMBROIDERY
75
2
Using the built-in camera
The camera built into this machine can be used to easily align
the embroidering position. This is useful for patterns which
need to be embroidered in particular position as shown
below.
a
Use a chalk pencil to mark the desired embroidering
position.
b
Hoop the fabric.
c
Select the pattern.
d
Touch to display the embroidering settings
screen.
e
Touch in the embroidering settings screen.
f
Select .
g
Touch to set the starting point to the left-lower of
the pattern.
1 If there are multiple patterns, select the pattern to be
used as the reference for the embroidering starting
position.
h
Touch .
i
Specify the appropriate image settings in advance.
(page 73)
• Better camera image results can be achieved with the
appropriate settings.
j
Touch .
1 Chalk pencil mark
• When hooping the fabric in the embroidery frame,
make sure that the embroidery pattern will fit within
the embroidering area of the frame being used.
1 Embroidering area
2 Embroidery pattern
size
3 Chalk pencil mark
• The different methods of rotating a pattern and
aligning its position while checking the image
shown by the camera are described below.
1 Mask outline of pattern
When selecting When selecting
The mask is based on the
pattern after it has been
rotated. If there are
multiple patterns, the
mask is created around all
patterns.
Since the mask is based
on the pattern before it
has been rotated, this
method is useful when
embroidering in a
location where the
pattern cannot easily be
aligned. If there are
multiple patterns, a
pattern can be selected as
the reference for the
embroidering starting
position.
a
a
To Next Page
Loading...
Need help?
General
Weight and Dimensions
