BASIC EMBROIDERY
47
2
Changing the size and the density of the
pattern
If is selected, you can change the pattern size while
maintaining the thread density. The machine recalculates the
stitch density automatically. With this function, the pattern
can be enlarged or reduced at a larger ratio than with normal
pattern resizing.
a
Select or in the size window.
*
: Change the pattern size while maintaining the
number of stitches. The thread density for the pattern
increases or decreases.
*
: Change the pattern size while maintaining the
thread density. After the pattern size is changed, the thread
density can be changed. The number of stitches is
recalculated depending on the pattern size.
b
When you select in step a, the message to reset
the pattern to its original size, angle and position will
appear. Touch .
c
Touch each key to change the pattern size, if desired.
d
Touch .
Trimming the threads between characters
If the machine is set to trim the threads between the
characters, the jump stitches between the characters are
reduced and any other necessary procedures after
embroidering are reduced. However, the embroidering time
will increase if the threads are trimmed between each of the
characters.
a
Touch so that it changes to .
• Each touch of the key turns the setting either on or off.
• This function cannot be used with character
patterns, frame patterns, repeated patterns or large
buttonhole patterns.
• Patterns with a large number of stitches (100,001
or more) cannot be resized while maintaining a
thread density.
• Depending on the pattern, the size of the pattern
increases up to 200% or reduces to 60%.
• You can also change the size by dragging the red
point around the pattern.
• When you select in step a, touch ,
and then change the thread density.
Threads are
not trimmed.
Threads are
trimmed.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
