MY DESIGN CENTER
155
4
Candlewicking Stitch
Chain stitch
E stitch
V stitch
Motif stitch
■ Region Settings
1 Shows the stitch type and color for the selected region.
2 Shows/Changes the stitch settings for the selected
region.
3 Choices for stitch type and color of selected region.
Fill stitch settings
Stippling stitch settings
Decorative fill stitch settings
b
Select the setting to be changed, and then change the
setting in the screen that appears. (In this example, the
embroidering direction will be changed.)
The setting screen appears.
c
Touch , and then use to change the
direction.
d
Touch to apply the setting.
* Change other settings in the same way.
[Size]
Increases/reduces the size of the stitch.
[Spacing]
Specifies the spacing of the candlewicking
stitch.
[Size]
Increases/reduces the size of the stitch.
[Thickness]
Sets repeated embroidering at the same
part.
[Stitch
Width]
Increases/reduces the size of the stitch.
[Spacing]
Specifies the spacing of the E stitch.
[Thickness]
Sets repeated embroidering at the same
part.
[Flip]
Specifies the decorative line showing up to
the inside or to the outside.
[Stitch
Width]
Increases/reduces the size of the stitch.
[Spacing]
Specifies the spacing of the V stitch.
[Thickness]
Sets repeated embroidering at the same
part.
[Flip]
Specifies the decorative line showing up to
the inside or to the outside.
[Size]
Increases/reduces the size of the stitch.
[Spacing]
Specifies the spacing of the motif stitch.
[Flip]
Specifies the decorative line showing up to
the inside or to the outside.
[Direction]
Specifies the embroidering direction. Select
[Manual] to change to the desired direction of
fill stitch.
[Density]
Specifies the stitch density of fill stitch.
[Pull
compensation]
Specifies to correct the shrinkage of the
pattern by slightly shortening or lengthening
the stitching. Change the setting after you
test embroidering the pattern and can check
the shrinkage.
[Under
sewing]
Select if you need or do not need the under
embroidery for the stabilized fabric.
[Run Pitch]
Specifies the length of a stitch of the
stippling stitch.
[Spacing]
Specifies the spacing between the stitches
when embroidering the stippling stitch.
[Distance]
Specifies the offset from the pattern outline.
[Stitch]
Specifies the stitch type.
[Size]
Increases/reduces the size of the pattern.
[Direction]
Specifies the rotation angle of the pattern.
[Outline]
Select whether [ON] or [OFF]. The outline is
also converted to embroidery data. If [ON] is
selected, the number of thread jumps can be
reduced.
[Random shift]
Randomly varies the line.
[Position
Offset]
Specifies the reference point for the pattern.
[Thickness]
Sets repeated embroidering at the same
part.
To Next Page
Loading...
