Canon imagePRESS C6010 - SDD Square Fold Booklet-Maker with Two-Knife Trimmer

Version 2 imagePRESS C6010 Customer Expectations Document Page 42
6.19 SDD Square Fold Booklet-Maker with Two-Knife Trimmer
Item Specifications
Input Accessory
Booklet Trimmer-D1 is required.
Pass Through Width
(No Trimming)
Approximately 8.27” (210 mm) to 12.60” (320 mm)
Booklet Trimming
Input Width
*1
: Approximately 8.27” (210 mm) to 12.60” (320 mm)
Output Width: Approximately 7.87” (200 mm) to 12.60” (320 mm)
Input/Output Length: Approximately 4.71” (120 mm) to 9.60” (244 mm)
Acceptable Paper
Weights
16 lb bond to 110 lb cover (60 to 300 g/m
2
)
Trimming Width
Each Side: 0.08” to 1.38” (2 mm to 35 mm)
Together: 0.16” to 2.76” (4 mm to 70 mm)
Asymmetrical Trim
(Offset Capability)
Approximately ±0.59” (15 mm)
Minimal Booklet Staple
Clearance (from Top to
Bottom)
Approximately 1.57” (40 mm)
Booklet Sheet Capacity
Up to 25 sheets (20 lb bond (80 g/m
2
))
Maximum Productivity
Up to 800 booklets/hour (up to 100 pages (20 lb bond (80 g/m
2
))
Power Source
120 V AC, 60 Hz, 15 A
Maximum Power
Consumption
Approximately 740 W
Dimensions (H x W x D)
51” x 62.3” x 51.1” (1,295 mm x 1,582 mm x 1,298 mm)
(with the conveyor tray fully extended)
Weight
Approximately 573 lb (260 kg)
*1 If a booklet’s input height is greater than 12.60” (320 mm), it must be trimmed to 12.60” (320 mm) or
fewer inches/millimeters.