Version 2 imagePRESS C6010 Customer Expectations Document Page 66
16.5 Note for Customers Who Cut Their Own Paper
Customers who cut their own paper may experience:
• An increase of paper dust in the machine
• Shortening the life of the machine’s fixing rollers due to excessive wear from the
rough side of the cut paper
• Paper jams due to paper dust getting into areas of the machine where it is not
meant to be
• Improper paper feeding
• Paper registration inaccuracies
Follow the precautions below to minimize the above issues:
• Have a process in place to regularly make sure that the cutting blades are
sharpened, and that cuts are made as clean as possible.
• Place the paper with the factory mill cut sides facing to the right (leading edge),
and to the front of the machine when feeding paper from a location other than the
stack bypass. If paper is fed from the stack bypass, place the paper with the
factory mill cut sides facing to the left (leading edge), and to the front of the
machine.
• Pay special attention to the paper grain orientation when cutting it. For more
information on paper grain, see “16.4 Paper Grain and Curl,” on p. 65.
• The best results for color consistency and front to back registration are obtained
by using factory mill cut, digital compatible paper.
16.6 Media Feed Locations
As with all Canon copiers, certain feed locations within the device are capable of
feeding specific media sizes and weights.
When considering media, make sure the media is within the proper size and weight
parameters of the feed locations. Once the desired media is selected the
appropriate feed location must be selected.
To Next Page
Loading...
Need help?
General