62
Setting
Note:
HDMI option can be chosen only in HDMI-1 and
HDMI-2 channel.
When the external device is connected to the HDMI
terminal of the projector, and the images can not be
projected normally, please switch on the Image or
Sound setting.
Press < MENU > button on the remote controller or on
the top control panel to display the OSD menu.Press
button to select the Setting menu ,then press
<OK> or
button to enter the sub-menu
.
1) Press
2) Press <OK> button.
Display instantly
.
3) Press ImageSound
4) Press <OK> button.
HDMI Setup
Note:
The best settings about projectors may differ slightingly from your external output device .
For external output, please refer to the instructions for use of the external device.
Auto Set the signal level automatically.
Limited Input the limited signal level from 16 to 235.
Full
Input the full signal level from 0 to 255.
HDMI Input Range
HDMI
When connect to the HDMI cable to tansmit images and audio while the users
don't need connect to audio signal separately.
Audio I/F
When the external audio signal would be input through AUDIO IN terminal.
MODE1-4
Change the HDMI reception level according to the AV device connected to the
HDMI input terminal. If noise appears in the image or the image does not appear,
change the settings.
Sound
EQ Setting
...
Setting
Direct Power On
Standby mode
High Altitude
Lamp control
Cooling fast
Closed caption
Key lock
lris
Sound
Off
Eco
Off
Normal
Off
On
HDMI Setup
HDMI Setup
To Next Page
Loading...
Need help?
General
