69
Advanced
Power management
To reduce power consumption and maintain life cycle
of lamp, the power management function will turn off
the projection lamp if your projector has no signals for a
period of time.
1) Press Power management
menu.
2) Press <OK > button.
3) Press button to switch required item.
Ready..........The POWER light indicator es
green when the lamp is fully cooled
down. The lamp turns on again if an
input signal is connected or any key
(except the power button ) on the
rear panel and remote controller is
pressed during this period of time.
Shut down....The projector shut down after the
lamp is fully cooled down.
Disable.........Disable the power management
function.
Timer............Once the input signal is interrupted
and no keys has been pressed for 30
seconds afterwards, the “No signal”
message displays in the timer. The
timer counts down until the lamp turns
off. Press arrow key to set up the timer
in range of 1~30 minutes.
Ready Countdown...· Set up the interval from ready
mode change to standby (0 to
30 minutes). A setting of zero
minute keeps your projector
from auto transition.
· Press the Power key to
change your projector from
ready to standby mode and
any other key to power it on.
Power management
Remaining time before
poweroff the lamp.
Power management
5 Min
5 Min
Ready
Disable
Timer
Ready countdown
Shut down
Advanced
Power management menu
Note:
Factory default for standby time: 5 minutes. Count down for ready mode: 5 minutes.
01: 20
No signal
To Next Page
Loading...
Need help?
General
