26
Setting the Remote ID to the Projector
To operate multiple projectors independently, set this ID function.
■ “Remote ID” is for a remote control.
■ “Control ID” is for a projector. See page 76.
1. Press the ID SET button for three seconds. The LED indicator on the remote control blinks.
2. To designate the Remote ID, press and hold the 2 digit number (01 ~ 99) each button for 1 second
at least. The remote control backlight blinks. Once initiated, the ID set procedure allows for ten
seconds to complete the process. After ten seconds, you must restart the procedure.
Note:
The factory default is “X / X”. “X” means all ID. And the left side is “Control ID”. The right side is
“Remote ID”. See page 76.
Clearing the Remote ID
Press the ID SET and CLEAR for ve seconds. The remote control backlight blinks signifying that the
ID setting is cleared.
Projector and Remote Control Buttons
The projector can be operated using the remote control or the buttons on the side of the projector. All
operations can be carried out with the remote control; however, the buttons on the projector are limited
in use.
To Next Page
Loading...
Need help?
General
