41
Recording
Using the ND Filter
When recording under bright conditions, the
camcorder closes down the aperture. When the
aperture value used is too large, the picture may
appear blurred. Turn the built-in ND filter on/off
according to the screen display.
When using a recording program other than M Manual and if the AGC switch is set to ON, the following
displays appear:
* If you have no external ND filter available, use the Tv mode and set a faster shutter speed, or use the Av mode and set
a smaller aperture.
Depending on the scene, the color may change when turning the ND filter on/off. Setting a custom
white balance may be effective in such case ( 66).
Screen display What it means What you should do
No display ND filter is not activated –
“ND” ND filter is activated –
“ND ” flashes ND filter required Turn on the ND filter
ND “ ” flashes Higher density setting or external ND filter
required.
Set the ND filter to a higher density setting or
attach an external ND filter to the lens*
ND “ ” flashes Built-in ND filter not required Turn off the ND filter
“ND” flashes in red Incorrect setting of the built-in ND filter Set the ND filter to an appropriate density
ND FILTER switch
AGC switch
To Next Page
Loading...
Need help?
General
Weight and Dimensions
