34
2.8 Power control
This section explains the power control functions.
No. Function Overview
1 Power On Turns the DT-X200 unit on.
There are 5 types of factor that turn power on.
2 Power Off Turns the DT-X200 unit off.
There are 6 types of factor that turn power off.
3 Memory check Checks the status of memory after power is turned on. Displays a
warning message on the screen if the memory is corrupted.
4 Power key control Settings can be made to disable the Power key or prohibit turning the
power off.
5 Reset and resume
control
There are reset methods based on various conditions (5 types).
A reset clears program execution status, but resume restores the
program execution state that preceded the power being turned off.
6
Recharge settings
*
Provide a functions from a tool to set the terminal recharge method.
Normal: Recharge normally.
Eco charge: Use Eco recharge
7 Power-saving control There are the following 5 control methods.
① Sleep
② Auto Power OFF (APO)
③ Dimming/ ABO (Auto Backlight OFF)
④ CPU clock frequency control
⑤ Virtual off (wireless standby)
* Refer to “3.1.8 Eco recharge settings” about the setting tool.
To Next Page
Loading...
Need help?
General