27
Quick Start Basics
1. Press [ON/OFF] (Power) to turn on the
camera.
2. Use [8] and [2] to select the language
you want and then press [SET].
3. Use [8] and [2] to select a date style
and then press [SET].
Example: July 10, 2016
YY/MM/DD
* 16/7/10
DD/MM/YY
* 10/7/16
MM/DD/YY
* 7/10/16
4. Set the date and the time.
Use [4] and [6] to select the setting you want to
change and then use [8] and [2] to change it.
To switch between 12-hour and 24-hour format, use
[4] and [6] to select “24h” and then use [8] and [2]
to change the setting.
5. After setting the date and time, use [4] and [6]
to select “Apply” and then press [SET].
• Each country controls its local time offset and the use of summer time, and so they
are subject to change.
• Removing the battery from the camera too soon after configuring time and date
settings for the first time can cause the settings to be reset to their factory defaults.
Do not remove the battery for at least 24 hours after configuring settings.
If you make a mistake configuring display language, date, or time settings with the
above procedure, refer to the following pages for information about how to correct
the settings.
– Display language: page 195
– Date and time: page 194
To Next Page
Loading...
Need help?
General
