37
Quick Start Basics
Use the following procedure to view snapshots on the camera’s monitor screen.
• For information about how to play back movies, see page 124.
• For information about images recorded using continuous shutter (CS), see page
126.
1. Turn on the camera and press
[p] (PLAY) to enter the PLAY
mode.
• This causes an image to appear on
the monitor screen.
• Information about the displayed
snapshot also is included (page 15).
• You also can clear the information to
view only the snapshot (page 16).
• You can zoom in on the image by rotating the zoom controller towards z
(page 130). If you are recording a snapshot that is very important to you, it is
recommended that you zoom the image and check its details after recording it.
2. Use [4] and [6] to scroll between images.
• Holding down either button scrolls at high speed.
• Half-pressing the shutter button while in the PLAY mode or while a menu screen is
displayed will switch directly to the REC mode.
Viewing Snapshots
To Next Page
Loading...
Need help?
General
