30
Quick Start Basics
To replace the memory card
Press the memory card and then release it.
This will cause it to pop out of the memory
card slot slightly. Pull the card out the rest
of the way and then insert another one.
IMPORTANT!
• Turn off the camera before replacing the
memory card.
• The back lamp (page 11) will flash green
for some time after you press [ON/OFF]
(Power) to turn off the camera. Never remove the memory card while the back
lamp is flashing green. Doing so can cause the image save operation to fail and
even damage the memory card.
Format a memory card on the camera before using it for the first time.
• Formatting a memory card that already has snapshots or other files on it, will delete
its contents. Normally you do not need to format a memory card again. However, if
storing to a card has slowed down or if you notice any other abnormality, re-format
the card.
• Be sure to use the camera to format a memory card. Formatting a card on a
computer will result in a non-SD standard format, which can greatly slow down
processing time and cause compatibility, performance, and other problems.
1. Turn on the camera and press [MENU].
2. Press [4], use [8] and [2] to select the “
¥
SETTING” tab, and then
press [6].
3. Use [8] and [2] to select “Format” and then press [6].
4. Use [8] and [2] to select “Format” and then press [SET].
5. Use [8] and [2] to select “Yes” and then press [SET].
To format (initialize) a new memory card
To Next Page
Loading...
Need help?
General
