105
Program 3
TE-3000S/4000F/4500F Dealer's Manual
I/O parameter table programming
Programming procedure
Program data (Address 01: for COM 1 port)
Program data (Address 02: for COM 2 port)
Description Choice Program code
International character set number for external/slip printer:
00: U.S.A., 01: France, 02: German, 03: U.K., 04: Denmark(1), 05: Sweden,
06: Italy, 07: Spain(1), 09: Norway, 10: Denmark(2)
International character set page number for external/slip printer:
For SP-1300:
0000: Multilingual + Euro, 0002: Multilingual, 0003: Portuguese,
0004: Canadian French, 0005: Nordic, 0006: Slavic, 0007: Cyrillic,
0008: Turkish, 0009: Windows code page
For other printers:
0000: Multilingual + Euro, 0002: Multilingual, 0003: Portuguese,
0004: Canadian French, 0005: Nordic
Always“0000”
External printer:
UP-350 = 00, UP-250 = 01
Connected device:
PC/ECR direct connection = 00, MODEM = 30,
External printer (as external printer 1 in printer connection table) = 80,
External printer (as external printer 2 in printer connection table) = 81
Baud rate:
Refer to the baud rate/device table.
Always“0”
::
D
16
D
15
: :::
D
14
D
13
D
12
D
11
; ;;;
D
10
D
9
D
8
D
7
::
D
6
D
5
::
D
4
D
3
:
D
2
;
D
1
Significant
numbers
Significant
numbers
Significant
numbers
Significant
numbers
Significant
number
Description Choice Program code
External printer/slip printer/scanner:
• External printer (D
4
D
3
= 80, 81): UP-350 = 00, UP-250 = 01
• Slip printer (D
4
D
3
= 70): SP-1300 = 00
• Scanner (D
4
D
3
= 20): HHS-15 = 00, Quick Scan 6000 = 01
Connected device:
Scanner = 20, Slip printer = 70,
External printer (as external printer 1 in printer connection table) = 80,
External printer (as external printer 2 in printer connection table) = 81
Baud rate:
Refer to the baud rate/device table.
Always“0”
D
16
~ D
7
: refer to the worksheet of the address 01.
::
D
6
D
5
::
D
4
D
3
:
D
2
;
D
1
Significant
numbers
Significant
numbers
Significant
number
63s 6 ::98s 6 ::6 a6 s
Note: Please perform the following procedure after this program.
1. Power off the register, and connect all peripheral devices to COM ports.
2. Power on all peripheral devices.
3. Flag clear the register.
To a new record
Record No.
PGM
Mode switch
Program data
To the next record
~
To Next Page
Loading...
Need help?
General
