Casio TE-3000S User Manual

25
Initialization
TE-3000S/4000F/4500F Dealer's Manual
Flag clear operation
1. Plug the power cord into an AC outlet.
2. Set the mode switch to PGM position and turn off the power switch.
(Refer page 14 of this manual for the location of the power switch.)
3. While holding down <RECEIPT FEED>, turn on the register.
4. Release <RECEIPT FEED>.
You should see “FFFFFFFFFF” on the display.
If 10 Fs are not shown or another character are shown,
immediately set the mode switch to OFF and restart from
the beginning of this procedure.
5. Press <SUBTOTAL> to complete.
After completion of flag clear, receipt is issued.
REG2 X1
REG1 Z1
OFF X2/Z2
RF
PGM
RECEIPT JOURNAL
FEED FEED
JOURNAL
FEED
Init 2 operation
After completion, receipt is issued.
1. Plug the power cord into an AC outlet.
2. Set the mode switch to PGM position and turn off the power switch.
(Refer page 14 of this manual for the location of the power switch.)
3. While holding down <RECEIPT FEED>, turn on the register.
4. Release <RECEIPT FEED>.
You should see “FFFFFFFFFF” on the display.
If 10 Fs are not shown or another character are shown,
immediately set the mode switch to OFF and restart from
the beginning of this procedure.
5. Enter “8888888888” and press <CHECK TEND> to complete.
REG2 X1
REG1 Z1
OFF X2/Z2
RF
PGM
RECEIPT JOURNAL
FEED FEED
JOURNAL
FEED
Note: After flag clear, clerk 1 is assigned automatically. So do not program clerk 1 as not assignable or
not operable in PGM mode.

Casio TE-3000S Specifications

General

Brand	Casio
Model	TE-3000S
Category	Cash Register
Language	English