Repeat these steps for each pair of buttons.
TREBLE
-
Slide the TREBLE lever up to increase
the
treble response.
If
the station is weak or noisy, slide the TREBLE lever down to reduce the
noise.
BASS
-
Slide the BASS lever up to increase the bass response. Adjust the
BASS lever to give a pleasing sound to your ear.
AUTO DNR
@
-
This unit is equipped with an automatic Dynamic Noise
Reduction system. DNR@reduces background hiss on
AM
and
FM
radio
broadcasts, as well as on cassette tapes. DNR@is a registered trademark of
National Semiconductor Corporation.
To
PIay
A
Cassette
Your tape player is built to work best with tapes that are
30
to
45
minutes
long
on
each side. Tapes longer than
that
are
so
thin
they may not work well
in this player.
Once the tape is playing, use the upper and lower
knobs
for volume, balance
and fade just as you do for the radio. A lighted arrow shows which direction
the tape is being played.
FWD
-
To rapidly advance the tape, press
4
or
b
in
the direction that the
amber arrow points and the tape will rapidly go forward until you press the
STOP-EJECT button lightly.
REV
-
To
rapidly reverse the tape, press
4
or
b
in the opposite direction
that the amber arrow points and the tape will rapidly reverse until you press
the STOP-EJECT button lightly.
PROGRAM
-
To go from one side of the tape to the other, press the
PWR-VOL-PROG-RCL knob.
STOP-EJECT
-
To remove the tape or stop the tape and switch to radio,
press
the
STOP-EJECT button.
If “Cln” (Clean) appears
on
the display when you insert your cassette tape,
your cassette player needs to be cleaned.
It
will still play cassette tapes but it
should be cleaned to prevent damage to your cassette tapes and the cassette
tape player. See “Care of Your Cassette Tape Player” later in this section.
After you have cleaned the cassette tape player, press and hold EJECT for
5
seconds to reset the the “Cln” indicator. The radio will display
“-
-
-”
to
show the clean feature has been reset.
3-9
To Next Page
Loading...
Need help?
General
