To
Lock
The System:
1.
Write down any
6
digit number and keep it in a safe place.
2.
Turn
the ignition to the
ACC
(Accessory) or RUN position.
3.
Press the PWR knob to turn the radio
off.
4.
Press the
1
and
4
buttons together. Hold them down until
“-
-
-”
shows
on the display.
You are now ready to enter your secret code. Don’t wait more than
15
seconds between steps.
5.
Press SET and
“000”
will appear on the display.
6.
Press the SEEK or
4
button to make the first number appear.
7.
Press
SCAN
to make the next two numbers agree with your code.
8.
Press
BAND
and
“000”
will appear again. Now you are ready to enter
the last three digits
of
your code.
9.
Repeat steps 6 and
7
for the last three digits of your code.
10.
Press
BAND
and “rEP’ will appear for
5
seconds and then
“OOO”
will
11.
Repeat steps
6
through
10.
This time
“SEC”
will appear
-
indicating
appear.
that the radio
is
secure.
To
Unlock
The System After A Power
Loss
When battery power is reapplied to a secured radio, the radio won’t turn on
and
“LOC”
will appear on the display.
Enter your secret code as follows. Pause
no
more than
15
seconds between
steps.
1.
Turn the ignition on. (Radio off.)
2.
Press the
SET
button. The display will show
“000”.
3.
Enter the six digits
of
the code following steps
6-9
above. The display
4.
Press the
BAND
knob and the time appears
-
indicating that the
will
show the numbers as entered.
disabling sequence was successful. If the display indicates
“SEC”,
the
numbers did
not
match and the unit is still secured.
3-16
To Next Page
Loading...
Need help?
General
