Disabling The
Theft
System
1.
2.
3.
4.
5.
6.
Press presets
1
and
4
for
5
seconds with ignition on and radio off. The
display will show “SEC”, indicating the unit is in the secure mode.
Press the SET button. The display will show
“000”.
Enter the first three digits of the code following steps
6
and
7
of the
preceding paragraphs (To Lock the System). The display will show the
numbers as entered.
Press the BAND knob. The radio will display
“OOO”.
Enter the second three digits of the code. The display will show the
numbers as entered.
Press the BAND knob.
If
the display shows
“-
- -
”,
the disabling
sequence was successful. The numbers matched the user-selected code
or the factory back-up code, and the unit is in the UNSECURED
mode.
If
the display shows “SEC”, the disabling sequence was
unsuccessful and the numbers did not match either of the codes and the
unit will remain
in
the SECURED mode.
Understanding Radio Reception
FM stereo will give you the best sound. But
FM
signals will reach only
about 10 to
40
miles
(16
to
65
km).
And, tall buildings or hills can interfere
with
FM
signals, causing the sound to come and go.
The range for most AM stations is greater than for
FM,
especially at night.
The longer range, however, can cause stations to interfere with each other.
AM can pick up noise from things like storms and power lines. Try reducing
the treble to reduce this noise if you ever get it.
AM Stereo means the Delco@ system can receive C-QUAM@stereo
broadcasts. Many AM stations around the count use C-QUAM@ to
produce stereo, though some do not. (C-QUAM is a registered trademark
of Motorola, Inc.) If your Delco@ system can get C-QUAM@, your
“STEREO” light will come on when you’re receiving
it.
Be aware that hearing damage from loud noise is almost undetectable until
it is too late. Your hearing can adapt to higher volumes
of
sound. Sound that
seems normal can be loud and harmful to your hearing. Take precautions by
adjusting the volume control on your radio to a safe sound level before your
hearing adapts to it.
3
To help avoid hearing
loss
or damage:
1.
Adjust the volume control to the lowest setting.
2.
Increase volume slowly until you hear comfortably and clearly.
3-17
To Next Page
Loading...
Need help?
General
