3.
Check both sides
of
the dipstick, and read the lower level. The fluid
level must be
in
the COLD area for a cold check
or
in the
HOT
area
or
cross-hatched area for
a
hot check.
4.
If
the fluid level is in the acceptable range, push the dipstick back in all
the way; then flip the handle down to lock the dipstick
in
place.
How
to
Add
Fluid
Refer
to
the Maintenance Schedule to determine what kind
of
transmission
fluid to use.
See
“Recommended Fluids and Lubricants” in the Index.
Add fluid only after checking the transmission fluid HOT.
(A
COLD check
is used only as
a
reference.) If the fluid level is low, add only enough of the
proper fluid to bring the level up to the
HOT
area for a hot check. It doesn’t
take much fluid, generally less than a int.
Don
’I
overjill.
We recommend
you use only fluid labeled DEXRON -111, because fluid with that label is
made especially for your automatic transmission. Damage caused by fluid
other than DEXRON@-I11 is not covered by your new vehicle warranty.
After adding fluid, recheck the fluid level as described under “How to
8
Check.”
When the correct fluid level
is
obtained, push the dipstick back in all
the wav: then flip the handle down to lock the dipstick in place.
6-
16
To Next Page
Loading...
Need help?
General
