Steering and Suspension Inspection
Inspect the front and rear suspension and steering system for damaged,
loose
or missing parts, signs of wear, or lack of lubrication. Inspect power
steering
lines
and hoses for proper hookup, binding, leaks, cracks,
chafing, etc.
Exhaust System Inspection
Inspect the complete exhaust system. Inspect the body near the exhaust
system. Look for broken, damaged, missing or out-of-position parts as well
as open seams, holes, loose connections, or other conditions which could
cause a heat build-up in the floor pan or could let exhaust fumes into the
vehicle. See “Engine Exhaust” in the Index.
Accelerator Control System
Lubricate all pivot points with engine oil, except the
TBI
throttle shaft.
Do
not
lubricate the cam pulley. Remove all external deposits from pulley.
Do
not oil
any
accelerator or cruise control cables. Replace any cables that have
high effort or excessive wear.
Drive Axle Service
Check readfront axle fluid level and add as needed. Check constant velocity
joints and axle seals for leaking.
Transfer Case
(Four-
Wheel Drive) Inspection
Every
12
months
or
at oil change intervals, check front axle and transfer
case and add lubricant when necessary. Oil the control lever pivot point and
all exposed control linkage. Check vent hose
at
transfer case for
kinks
and
proper
installation.
More frequent lubrication
may
be required
on
off-road
use.
7-39
To Next Page
Loading...
Need help?
General
