To
Resume
a
Set
Speed
Suppose you set your Cruise Control at a desired speed and
then
you apply
the brake. This,
of
course, shuts
off
the Cruise Control. But
you
don’t need
to reset
it.
Once you’re going
about
25
mph
(40
km/h) or more, you
can
move
the Cruise
Control switch from
ON
to
R/A
(Resume/Accelerate)
for about half a
second.
You’ll go right back up to your chosen speed and stay there.
Remember,
if
you hold the switch at
R/A
(Resume/Accelerate) longer than
half
a
second, the vehicle will keep going faster until you release the switch
or
apply the brake. You could be startled and
even
lose control.
So
unless
you want to
go
faster, don’t hold
the
switch
at
R/A (Resume/Accelerate).
To
Increase Speed While Using Cruise Control
There are two ways to go to a higher speed.
1.
Use
the accelerator pedal to get to
the
higher speed. Push the button at
the end
of
the lever, then release the button and the accelerator pedal.
You’ll
now cruise at the higher speed.
2-40
To Next Page
Loading...
Need help?
General
